Trenutno niste prijavljeni. Za prikaz svih foruma potrebna je registracija.
Ima li tko koji Automotive standard.
Branko
Offline
koji tip?
Offline
Ako mislite sa ovim tipom interfejs? Meni ne treba shema interfejsa. Ja molim za dokument standarde:
SAE standards documents on OBD-II
* J1962 - Defines the physical connector used for the OBD-II interface.
* J1850 - Defines a serial data protocol. There are 2 variants- 10.4 kbit/s (single wire, VPW) and 41.6 kbit/s (2 wire, PWM). Mainly used by US manufacturers, also known as PCI (Chrysler, 10.4K), Class 2 (GM, 10.4K), and SCP (Ford, 41.6K)
* J1978 - Defines minimal operating standards for OBD-II scan tools
* J1979 - Defines standards for diagnostic test modes
* J2012 - Defines standards trouble codes and definitions.
* J2178-1 - Defines standards for network message header formats and physical address assignments
* J2178-2 - Gives data parameter definitions
* J2178-3 - Defines standards for network message frame IDs for single byte headers
* J2178-4 - Defines standards for network messages with three byte headers*
* J2284-3 - Defines 500K CAN Physical and Data Link Layer
[edit] ISO standards
* ISO 9141: Road vehicles — Diagnostic systems. International Organization for Standardization, 1989.
o Part 1: Requirements for interchange of digital information
o Part 2: CARB requirements for interchange of digital information
o Part 3: Verification of the communication between vehicle and OBD II scan tool
* ISO 11898: Road vehicles — Controller area network (CAN). International Organization for Standardization, 2003.
o Part 1: Data link layer and physical signalling
o Part 2: High-speed medium access unit
o Part 3: Low-speed, fault-tolerant, medium-dependent interface
o Part 4: Time-triggered communication
* ISO 14230: Road vehicles — Diagnostic systems — Keyword Protocol 2000, International Organization for Standardization, 1999.
o Part 1: Physical layer
o Part 2: Data link layer
o Part 3: Application layer
o Part 4: Requirements for emission-related systems
* ISO 15765: Road vehicles — Diagnostics on Controller Area Networks (CAN). International Organization for Standardization, 2004.
o Part 1: General information
o Part 2: Network layer services
o Part 3: Implementation of unified diagnostic services (UDS on CAN)
o Part 4: Requirements for emissions-related systems
Offline